SCHWINN STING-RAY KRATE 16" HURET SPEEDO HUB DRIVE BICYCLE BIKE SPEEDOMETER

Description

(This is a new auction, not a relisting!)
This is a clean used example (with added New Old Stock parts) of
everything
you need for the southern end of your 16" Schwinn Krate Sting-Ray speedometer installation: a freshly re-lubed vintage 16" Schwinn speedometer drive by Huret, Schwinn part number 08 468, for Schwinn Krates or other bikes with 16" front wheels, complete with NOS white dust cap, an original NOS bushing and washer kit, NOS strap and a clean NOS foam dust seal.
Huret produced several variations of the 16" Krate drive with different markings. Most are stamped on the side with both the wheel size (16") and the output ratio in French notation ("1,2"), but variations include this one, from a batch that had no wheel size stamped on the side. (Its output ratio is correct regardless.) Another batch was produced with the wrong wheel size stamped on the side, 15" instead of 16", and those turn up here on eBay from time to time.
This drive hub is a short-arm design, and will fit the slots in the right side of an Atom drum brake if so equipped. Its drive ratio is 1:1.2. This drive is compatible with the chrome Schwinn Approved Huret speedometers and drive cables (not included; see my other auctions for examples of those), as well as Huret-branded bicycle speedometers.
I'm also including an
original
New Old Stock accessory hardware kit consisting of:
One 5/16" axle bushing
(silver), for Krates with standard front axles and coaster or caliper brakes
One 3/8" axle bushing
(black), for Krates with Atom drum front brakes
Three 13/16" installation washers,
to be used to clear either the inner face of the front fork or the axle cone nut, as needed
One flexible plastic drive cable tie strap
One foam dust ring seal
This drive is in clean used condition and full working order.
I've cleaned the hub and repacked it with fresh grease, and it turns smoothly.
The two drive arms have a 3 1/8" (80mm) span, each extending 1 9/16" from the center of the axle hole.
The axle hole in the center is 7/16" diameter
.
I
am also including a free scanned reprint of an original instruction sheet to help you get it all installed.
NOTES:
This is not for quick-release front hubs.
This is only for bicycles with bolt-on front axles.
This is not for Stewart-Warner speedometers.
This is a Huret speedometer part.
This auction is for the drive hub and hardware kit only.
If you do not see it in the photos, it is not included!
F
ree Shipping applies to domestic (U.S.) First Class mail only.
See the Shipping and Handling section of this listing for all rates, including international Shipping charges. Please be sure you know the Shipping charge to your address
before
bidding. Import duties, taxes and charges are not included in the item price or shipping cost. You will need to pay these charges to your post office. (They are not charges from me.) These charges are the buyer's responsibility. Please check with your country's customs office to determine what these additional costs will be prior to bidding or buying.
Sorry, we do not understate package value, or mark it as a Gift.
See my other auctions for more vintage Schwinn speedometer items! Except where noted, combined shipping is available for all items ending on the same evening.
Please do not copy any part of this listing without permission.